Some time back I submitted a question about whether the WPF Syntax editor could be used as a VB Expression Editor for Rehosted WF 4 Designer. At the time I was correctly advised that this functionality would require Single-Line Mode and Automated Intelliprompt which was not then available in the WPF version (Winforms only). Seems like posts which refer to this functionality now have the following post attached to them
Version 2011.1 build 0543
Released on 05/23/2011, which was after the last post in this thread.
Does this mean that this functionality is now in the current built ?
I'm referring to the threads below:
Single-Line Mode
http://www.actiprosoftware.com/support/forums/viewforumtopic.aspx?ForumTopicID=4015
Automated Intelliprompt
http://www.actiprosoftware.com/support/forums/viewforumtopic.aspx?ForumTopicID=5548
Looking forward to your response.
Thanks
[Modified at 05/31/2011 02:06 AM]
Version 2011.1 build 0543
Released on 05/23/2011, which was after the last post in this thread.
Does this mean that this functionality is now in the current built ?
I'm referring to the threads below:
Single-Line Mode
http://www.actiprosoftware.com/support/forums/viewforumtopic.aspx?ForumTopicID=4015
Automated Intelliprompt
http://www.actiprosoftware.com/support/forums/viewforumtopic.aspx?ForumTopicID=5548
Looking forward to your response.
Thanks
[Modified at 05/31/2011 02:06 AM]